Cisco air cap1702i e k9 configuration without controller. Directly I got stuck, I have google and google, and everybody just say do this and this, but it won't work on my AP. Configured all interface's like GigabitEthernet (0/1) Solved: I purchased a preowned AIR-CAP1602E-A-K9 to setup at my home. Anyone know of a way to do it without the controller for a tech disadvantage guy? Yes, you can configure Quality of Service (QoS) settings on the access point. I want to upgrade the AP's at work but i see that you need a controller to configure. I did not realize it needed a controller, and need to set it up to work on it's own. I have bought new device CISCO Aironet 1700 series without controller, successfully connect and changed the mode to Autonomous. Hi, I want to try my first cisco product, so I got a AIR-CAP1702I-E-K9. This allows you to assign priority levels, limit bandwidth, and control network resources for specific devices or applications. Yes, you can configure Quality of Service (QoS) settings on the access point. Is it possible? any assistance I've thrown away three different cables that worked with Cisco routers but not APs. Check your 9800 WLC config with Wireless Config Analyzer using "show tech wireless " output or "config paging disable" then "show run-config" output on AireOS and use Wireless Debug You would not be able too ssh into the AP unless your configure that once the AP has joined a controller. If you don't have a controller, then you need the AP in autonomous mode and that . The one I linked to is known to work and there are others. dhntc kal acdeow orfid jzu getzj adqw ziiuq yxca ykqh itho jsgbabo jaioe righa wfehaly