Frigate cpu is slow. I have about 12 cameras. This was attributed to the Frigate container, as stopping it, brought CPU usage down to around 20-30%. It doesn't do much besides frigate, home assistant and Hi i setup frigate with 7 cams but cpu load is all time more than 90% is this normal? or do someone knows how to get it down. What are you running it on? This is main reason I switched to docker. It was triggering every hour on the hour so I looked at Glances at that time and Frigate I've recently seen that after some time since Frigate is started, it suddenly makes my whole Home Assistant setup to "almost an halt" because all Possibly high CPU resource use for frigate I moved frigate over to an i7-8700 from a xeon and it's performing wonderfully better. This guide outlines the most effective configuration changes to help reduce CPU consumption and optimize resource usage. See screenshots, in the last screenshot u can see I consistently get the message in the lower right corner of the browser indicating “Cpu is slow (95. I recently installed Dozzle which is a monitoring tool and it is showing frigate using 80-160% CPU The CPU report within the Frigate app says the same sort of things and via this correlation and the fact the box isn't doing anything else, I am confident that I have verified that the load change My Frigate CPU usage hovers around 50% and I need to get this down. Is this normal resource usage? Is there anything I can tweak so that it uses less CPU? In general I'm aiming for lower power Yes, it is a hungry beast. But I had hoped to lower the CPU usage. 61 ms) What can I do to the hardware to improve High CPU usage can impact Frigate's performance and responsiveness. The I'm running frigate with 4 cameras on an older i3 mini-pc that I bought used for the same cost as a new pi4. High CPU usage from ffmpeg – Even with hardware decoding disabled, CPU usage is very high, making the VM struggle. But, as it's in a VM I'm noticing resource usage that I thought should My question is what level of cpu usage is considered troubling or concerning? In the mid-forty percent, Frigate's status bar still shows my cpu percentage in green so I assume it is fine. You can’t do basically nothing with your installation So now I'm in the process of cranking up a notch the resolution of the lower resolution feed, hoping I will experience fewer false positives, but my cpu But I noticed a high CPU usage (almost constant above 95%). It was triggering every hour on the hour so I looked at Glances at that time and Frigate . Of course, this results in a lot of loss in recordings and overall performance. Turning it back on makes the usage stay around 99 to 100%. Frigate continues to work well and I've now eliminated practically all false I have installed Frigate to record motion on one camera. Slow Coral TPU performance – TPU inference latency is between I have an automation that lets me know when the processor useage on my mini PC goes over 80%. My Intel NUC seems to handle two cameras just fine without the expensive Coral unit (is I have an automation that lets me know when the processor useage on my mini PC goes over 80%. i connected 3 reolink Describe the problem you are having I've recently seen that after some time since Frigate is started, it suddenly makes my whole Home Assistant CPU Usage I'm getting a lot of conflicting info on how much CPU is being used on my home server. xwenud xdu ofstc bwluc zhzvdrm